How-To Install a Truck Covers USA Roll Top Bed Cover
Read 106,607 TimesPosted Oct 6, 2006, 2:24 ET by jason
  |   Permalink  |  Print  |  Email to Friend
More in: How-To, Bed & Cargo, Exterior

Story & Video: Jason Coe
Photos: Brian Olhausen

Click to enlargeHave you ever tried to transport an engine hoist in the bed of your truck when you have a bulky hard top cover connected to the bed? What a pain! Truck Covers USA is revolutionizing the automotive industry with a blazing new high quality, scratch resistant roll up hard tonneau cover. These covers can even hold over 500 lbs! Whether it's for work or for play, these covers rock! Installation is cake and takes only minutes. Check it out! www.truckcoversusa.com

Installation Time: 1-2 hours

Vehicle: Ford 2006 F-250 Super Duty

Tools Required: Sockets, screw driver, 1.25” (32mm) hole saw

Installation Steps

Click to enlargeInstall the canister towards the front of the truck bed making sure you center the canister with the lips resting on both sides of the truck bed.



Click to enlargeLocate the left “LH” and right “RH” side rails and place them against each bed rail.



Click to enlargeSecure the side rails and align with the canister by using the rail clamps and shims provided. Clamp the side rail onto the bed near the canister and shim near the tail gate. It will be helpful if a friend can pull the rail tightly to the bedside while the other installs the clamps.



Click to enlargePull the curtain out making sure it slides smoothly. Pull it all the way till the curtain locks when fully extended then install the canister lid.



Click to enlargeFit the drain hoses. You do this buy drilling a 1.25” (32mm) hole saw through the inside panel of the truck bed roughly 8” below the rear drain plugs. Place the two drain hose grommets into the new holes and cut the suitable length of drain hose, pushing on end over the drain plug and the other through the grommet.



Installation Video Overview

Click to watch the video!
Click image above to watch the video!

Finally, adjust the lock assembly hidden under the rails and you’re good to go!

These covers come with a textured powder coated finish (color matching also available), weather resistant, features a 2 year limited warranty, locks every 12 inches and is the toughest retractable aluminum cover available. Special thanks to Rhino Linings in Temecula, Caifornia, for spraying the truck prior to our tonneau installation.

You can see this truck in the Rhino Linings booth at SEMA 2006 in Las Vegas, NV.

Sources

Truck Covers USA
6875 Nancy Ridge Drive #C
San Diego, CA 92121
858-622-9135





Discuss now in our forums: Bed and Cargo   Exterior

Related Articles

Stepping Up Is Easier Than Ever
Road Armor Rocks!
Line-X: Not Just Another Spray In Liner
Spice up Your Truck's Rearend
The Computer Controlled Tailgate
SUV Concepts Debuts Navigator Kit
New Products: Grillin' Up A Super Duty
New Product: Orion HD Transfer Case
New Product: Carbon Composite Deluxe Front Replacement
New Product: 04 F-150 Shaker System



Truckblog Monthly Newsletter
Subscribe to the Truckblog Monthly Newsletter now to receive
the latest that Truckblog has to offer for your truck and SUV!

CLICK HERE TO SUBSCRIBE NOW!

Please read our Privacy Policy

 
                               
                                       
Please visit our supporting sponsors. Advertise here!