How-To Install A StreetGlow Pro-Series Strobe Light Kit
StreetGlow Inc of Wayne, New Jersey, California, are the performance lighting experts when it comes to automotive aftermarket lighting systems. Known for their massive presence in the Universal Studios’movies, “The Fast and the Furious” as well as, the sequel, “2 Fast 2 Furious”, StreetGlow have been lighting up custom vehicles since 2000. Due to their ease of installation, we opted for a Pro-Series Strobe Kit on Project Truckblog.
What comes in the box?
• (4) “U” shape bulbs
• (6) 15′ cables
• (1) Four port 75 watt power supply
• Detailed Instructions
The following is a how-to installation of the StreetGlow Pro-Series Strobe Light Kit.
| SOURCES:
StreetGlow |
Installation Steps
The first part of installing the strobe lights is determining where you want to mount the strobes themselves. We opted for the lower half of our tail lights and the corner amber areas of Project Truckblog’s headlights. Once you’ve located where you will mount the strobe, use a drill bit to cut a small hole but big enough to mount the strobe.
Then, mount the strobe by pushing it in past its grommit. Do this for all desired strobe locations. For our headlight housings, we decided to take out the stock amber light bulb and use its location for the strobe. No drilling was needed.
Next, run the wiring cables from your installed locations to the area where you want to mount the system’s brain. We chose to install the brain behind the dash. We also ran our wiring down the frame rails near the cab and secured them with zip ties.
Finally, plug the wires you ran into the brain assembly, hook up your power lead from the brain to the battery, locate your toggle switch location and you’re done!
| SOURCES:
StreetGlow |
Tags: Exterior, Mobile Electronics, Project Truckblog
Category: How-To
